Traxxas 6995 Bedienungsanleitung PDF herunterladen (Seite 1)

Source Filename: C: \ PTC \ .wwgm \ .ws \ trx-wcapp.traxxascorp.com \ SolidWorks Files \ SolidWorks Files.SOLIDWORKS \ ORC003 Display Chassis Rear For Exploded View

KC1729 120823

Covers Part #6995

Completed Installation

Body Cutout

Instructions

www.TRAXXAS.com

Traxxas, 1100 Klein Road, Plano, TX 75074,

Phone: 972-265-8000, Fax: 972-265-8011, e-mail: [email protected]

If you have questions or need

technical assistance, call Traxxas at

1-888-TRAXXAS

(1-888-872-9927) (U.S. residents only)

Funny Car

Display Chassis

Body Mounting

Instructions

The body will rest on the display chassis’ exhaust pipes when lowered.

To adjust the height of the body, carefully trim away the exhaust-

clearance area as shown. Remove a small amount of material at a

time until the body is sitting properly over the chassis.

For best results, used curved scissors designed for trimming

lexan bodies. Or, trace the area using a hobby knife to score it,

then ﬂex the lexan and peel out the waste material.

Use caution when handling a hobby knife.

1. (Skip to step 2 if you are installing a body you

have purchased separately). Dismount the body

from your vehicle by removing the screws that

secure the body pivot to the rear subframe.

2. Install the rear of the body on the display chassis

by inserting the supplied hardware through the

body pivots and chassis plates, then tighten

them in the plastic spacer bar.

All parts contained in this model, including the

wheels and tires, are for static display only.

DO NOT install on running vehicles.

6995-Funny_car-Chassis-Display-Cutout.indd 1 9/6/12 11:22 AM

Funny Car 1
Display Chassis 1

Inhaltsverzeichnis

Seite 1 - Display Chassis

Source Filename: C: \ PTC \ .wwgm \ .ws \ trx-wcapp.traxxascorp.com \ SolidWorks Files \ SolidWorks Files.SOLIDWORKS \ ORC003 Display Chassis Rear For